Lift cables carry serious load alongside the springs. When one frays or snaps, we replace both cables as a pair and check the drums for wear.
A single-cable fix often means a second failure soon after. We explain the pair-replacement logic upfront.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
Worn or cracked cable drums get replaced alongside the cable itself, since a damaged drum will fray the next cable too.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Technicians carry standard cable gauges and lengths for most residential doors.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
Most cable replacements are completed same-day, typically within one to two hours once the technician arrives.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Mount Vernon to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Mount Vernon, GA